MaxxFlow
For measurement of high mass flow rates for dry solids from the exit of pre feeding devices,
eg screw conveyors, air slides, rotary valves, bucket elevators, etc.
-
Most non-metallic solids can be measured
-
Can be installed on round pipes or ducts
-
No real upper limit of mass flow
-
Maximum pressure 10 bar
-
Dust tight
-
No flow restrictions to the process flow (wear resistant ceramic liner)
-
The mass flow measurement is independent of flow characteristics
-
Maximum temperature, 12O °C
-
Can be installed at an angle
-
Small footprint, 220 mm (DN 100), 290 mm (DN 150), 310 mm (DN 200)
-
No moving parts, hence no maintenance
Sensor
Housing
Inner pipe
Protection category
Operating Temperature
Max working pressure
Working frequency
Transmitting power
Weight
Accuracy
|
Steel St52, powder-coated
(optional stainless steel 1.4571)
NW 100/150/200mm
Flange according to EN 1092-1/PN10
Ceramic Al2O3
IP65
Sensor pipe: -20 - +120°C
Sensor electric: 0 - +60°C
1 bar, optional 10 bar
88 kHz
Max 2 mW
Depending on model
± 3%
(based on end of measuring range and calibrated material) |
Transmitter
Power Supply
Power consumption
Protection category
Operating temperature
Dimensions
Weight
Cable glands
Terminal clamp wire size
Current output signal
Alarm output
Error output
Data backup
Impulse output
RS-485 |
110/240V AC, 50 Hz, 24V DC
20W/24VA
IP65 to EN 60 529/10.91
-10 - +45°C (14 - 113°F)
258 x 237 x 174mm (W x H x D)
Approx 2.5kg
3 x M16 (4.5 - 10mm Ø)
0.2 - 2.5mm² (AWG 24 - 14)
2 x 4-20mA (0-20mA), load < 500^
Relay with toggle switch - max
250V AC, 1A
Flash memory
Open collector - max. 30V, 20mA
ModBus |